c0nr4d.technix forum logs
Would you like to react to this message? Create an account in a few clicks or log in to continue.
c0nr4d.technix forum logs

information technology, computer hardware/software, data communications, modding, networking, computer tips, web-log & discussions... archive your brains...
 
HomeGallerySearchLatest imagesRegisterLog in

 

 SE-P990i & P1i Fast port diagram

Go down 
AuthorMessage
xcon

xcon


Number of posts : 66
Registration date : 2008-11-13

SE-P990i & P1i Fast port diagram Empty
PostSubject: SE-P990i & P1i Fast port diagram   SE-P990i & P1i Fast port diagram Icon_minitimeTue Aug 25, 2009 2:42 pm

SE-P990i & P1i Fast port diagram Se_k750


SE-P990i & P1i Fast port diagram Se_k750


for D750i, K310a, K310i, K310c, K320i, K510a, K510i, K510c, K610i, K610im, K618i, K750c, K750i, K758c, K790i, K790c, K790a, K800i, M600i, M608c, S500i, P990i, V630i, W580i, W710i, W710c, W712a, W850i, W950i, Z520a, Z520i, Z520c, Z525i, Z525a, Z530c, Z530i, Z550c, Z550i, Z550a, Z558i, Z558c, Z610i, Z710c, Z710i, W300i, W300c, W550c, W550i, W600c, W600i, W700c, W700i, W760i, W800c, W800i, W810c, W810i, W830i, W830c, W900c, W900i, W958c and some other new SE


Pin Signal Description
1 USB +5V in USB 5V supply - in K750 not used
2 SP_REF Reference / headphone gnd
3 Mic+/AUXIN_L Microphone+ / AUX Input - left / Short to 4 for Answer button (*)
4 Mic-/AUXIN_R Microphone- / AUX Input - right / Short to 3 for Answer button (*)
5 DFMS/SP_L DFMS / headphone speaker - left
6 DTMS/SP_R DTMS / headphone speaker - right
7 VIDEO/STB Video / strobe
8 VPPFLASH Short to pin 9 for handsfree detection (use a 130 ohm r)
9 GND Ground
10 CTMS / USB DATA+ CTMS / USB+ (data) - in K750 not used
11 CFMS / USB DATA- CFMS / USB- (data) - in K750 not used
12 Charge In Battery charging (+5V) - in K750 not used

Used Shortcuts:

* CTMS stands for Control To Mobile Station
* CFMS stands for Control From Mobile Station
* DTMS stands for Data To Mobile Station
* DFMS stands for Data From Mobile Station

Notices:

The key is near pin1

If you want make a stereo converter with a SE socket, you will be used 5 and 6. pins. It may not work well with an amplifier due to low output i.e just enough to power for headphones . (May need pre-amp).

Suggestion:

to make a stereo-amp using the cell phone you must to be Short the pins 8 and 9. And connect the outputs (L) (R) (GND) using the pins 5 = (L) 6 = (R) 9 = (GND).

However, note that the Original Sony-Erisson Walkman headset is connected using pins 2 (GND), 5 (L) and 6 (R).



(*) Use a push button to shortcircuit pins 3 and 4 to pick up / hand up / off an incoming call
Back to top Go down
xcon

xcon


Number of posts : 66
Registration date : 2008-11-13

SE-P990i & P1i Fast port diagram Empty
PostSubject: Re: SE-P990i & P1i Fast port diagram   SE-P990i & P1i Fast port diagram Icon_minitimeTue Aug 25, 2009 2:44 pm

Sony Ericsson DCU-60 usb cable schematic pinout

Pin Signal Description
1 USB +5V connect to PC USB pin 1
9 Gnd connect to PC USB pin 4
10 USB DATA+ connect to PC USB pin 3
11 USB DATA- connect to PC USB pin 2
12 Charge In should be connected to PC USB pin 1 for charging. Anyway, charging should proceed without this connection in some cases.
May be used as a data or service cable (with some programs)
Back to top Go down
 
SE-P990i & P1i Fast port diagram
Back to top 
Page 1 of 1
 Similar topics
-
» PS/2 to USB wiring diagram
» Sony Ericsson P1i vs P990i photos

Permissions in this forum:You cannot reply to topics in this forum
c0nr4d.technix forum logs :: c0nr4d.technix - Forum Site :: SE P1i & P990i modders/users-
Jump to: